Page 1 of 1

Planner Empty after restore

PostPosted: Wed Jan 23, 2013 7:53 pm
by flyboy1972
I have just got a new Amstrad DRX890 Sky HD box from Sky. I used Copy+ to copy my recordings to a portable HDD from my old Sky+ box (a Pace V3 Sky+ box // Pace TDS470NB // 9F22nn). The copy and restore process appeared to complete OK. All programs appeared to copy and restore OK without any errors. After restore I got the option to convert the format (big / little Endian) . I have tried all 3 options, but the planner is empty on the new Sky HD box after the restore. I have also tried rebuilding the planner.

Any help would be appreciated.

Thanks

Re: Planner Empty after restore

PostPosted: Fri Apr 12, 2013 7:39 pm
by simie32
I've had the same issue as this. Any suggestions?

Re: Planner Empty after restore

PostPosted: Sun May 12, 2013 11:04 am
by blujoose
i have just had exactly the same problem, same start box (pace tds470nb) copied across to an external hd as an image and then (apparently) successfully copied to the sata disk inside the amstrad 890.
all boots up fine, nothing in planner, tried planner rebuild, still nothing.

Re: Planner Empty after restore

PostPosted: Tue Jun 18, 2013 8:17 pm
by teresasadler
I've also got this after copying over from an ancient Pace TDS470N Sky+ to an Amstrad DX890 HD and rebuilding the planner.

There seem to have been quite a few reports of this in the forum. Any advice, please?

Re: Planner Empty after restore

PostPosted: Tue Jun 18, 2013 10:45 pm
by pcbbc
Please Google for and use ExPVR for HD boxes (not my software).
Copy+ is no longer compatible with HD boxes since the move to. The Darwin planner.
Sorry.