Page 1 of 1

Windows 7 won't find source drive

PostPosted: Thu Sep 29, 2011 6:40 pm
by davet101
Hi,

I have successfully installed copy +, I have my source drive in a USB2 to SATA adaptor and my destination dive connected to a SATA port.

In disk management, my source drive is Disk 6, and is marked as FAT32, healthy (active, primary partition).
My destination drive is Disk 1 (Unallocated but I have initialised the disk and set it to MBR). This is a 1TB drive.

My problem is that even when run as administrator, Copy+ can find my destination drive (Disk 1) but not my source drive.

I am running windows 7 64bit.

Any ideas?

Many thanks

Re: Windows 7 won't find source drive

PostPosted: Sat Jan 28, 2012 9:50 pm
by simpaty
I have got exactly same issue, i also tried with a windows 7 32bits...frustruating