Hi,
I have successfully installed copy +, I have my source drive in a USB2 to SATA adaptor and my destination dive connected to a SATA port.
In disk management, my source drive is Disk 6, and is marked as FAT32, healthy (active, primary partition).
My destination drive is Disk 1 (Unallocated but I have initialised the disk and set it to MBR). This is a 1TB drive.
My problem is that even when run as administrator, Copy+ can find my destination drive (Disk 1) but not my source drive.
I am running windows 7 64bit.
Any ideas?
Many thanks